XL6009 Step Up Module with Display
- Input Voltage: 3 ~ 32 V
- Output Voltage: 5 ~ 40V
- Transfer Efficiency: 94%
- Operating Temperature: -40°C to +85°C
- The booster works below 5V normally, but the display does not work
₹249.80₹280.84Incl. of GSTXL6009 Step Up Module with Display
₹249.80₹280.84Incl. of GSTHC-05 Wireless Bluetooth Module without Base Plate
- Bluetooth protocol: Bluetooth Specification v2.0+EDR.
- UART interface with programmable baud rate
- With integrated antenna
- With edge connector
- Frequency: 2.4GHz ISM band.
- Modulation: GFSK(Gaussian Frequency Shift Keying).
- Emission power: =4dBm, Class 2.
- Sensitivity: =-84dBm at 0.1% BER.
₹264.00 Incl. of GSTHC-05 Wireless Bluetooth Module without Base Plate
₹264.00 Incl. of GSTCC1101 RF Transceiver Module – 868Mhz
- Support FSK, GFSK, ASK / OOK and MSK
- Programmable data rate: 1.2 to 500k Baud
- Vertical Pin header (1.27mm pitch)
- Low voltage input (1.9~3.6V)
- SPI interface
- Independent 64-byte RX and TX data FIFOsCC1101 Core, 433MHz Wireless function
₹265.00 Incl. of GSTCC1101 RF Transceiver Module – 868Mhz
₹265.00 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
- Operating Voltage: 3.3V – 24V (TTL level for I2C/UART), 3.3V (TTL for SPI)
- Interface: I2C, SPI, High-Speed UART (HSU)
- Communication Distance: 5cm to 7cm (NFC and RFID)
- PCB Antenna: Built-in, providing 4cm to 6cm communication range
- Works as an NFC device or RFID reader/writer
₹268.00 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
₹268.00 Incl. of GSTNodeMCU ESP8266 CP2102 Wifi Development Board
- Based on ESP8266-12F/12E
- Easy to use wifi development board with Lua Scripting
- Open source firmware and development kit
- Input Voltage: 5V to 12V
- Built in USB to TTL Serial using CP2102
₹270.50 Incl. of GSTNodeMCU ESP8266 CP2102 Wifi Development Board
₹270.50 Incl. of GSTCH376S USB Disk Read Write Module
- Supply Voltage: 5V
- Internal curing CH376S chip FAT file system, file operations simple and fast
- Support including USB thumb drives, USB hard drives, USB flash drives, and USB storage devices, USB card reader
- Compatible with CH372, host compatible with CH375
₹289.00₹306.80Incl. of GSTCH376S USB Disk Read Write Module
₹289.00₹306.80Incl. of GSTDIY Sanitizer Dispenser Module
- Usable with Ultra Sonic, IR Sensor, and other sensor types
- Micro controller Based Design
- Default Detection Distance: < 6 inches
- Default Trigger Time: 200 mS
- Input Voltage: 12 VDC
- Max Current Consumption: 1 A
- Output Voltage: 12 VDC
₹295.00 Incl. of GSTDIY Sanitizer Dispenser Module
₹295.00 Incl. of GSTXL4016 Step Down Module – Constant Current / Constant Voltage Output – 1.25 to 32V Output – 300W
- Wide 8V to 36V Input Voltage Range
- 8A Adjustable Constant Output Current Capability
- Output Adjustable from 1.25V to 32V
- Maximum Duty Cycle 100%
- Minimum Drop Out 0.3V
- Fixed 180KHz Switching Frequency
₹297.00₹335.12Incl. of GSTXL4016 Step Down Module – Constant Current / Constant Voltage Output – 1.25 to 32V Output – 300W
₹297.00₹335.12Incl. of GSTMirror Touch Sensor AC – 3 Colour Touch + Dimming
- Functions : Tricolor + Dimming
- Input Voltage: 110V – 240VAC
- Max Load: 12VDC 1A 12W Max
- LED Indicator: Blue (ON Mode) , White (OFF Mode)
₹309.00 Incl. of GSTMirror Touch Sensor AC – 3 Colour Touch + Dimming
₹309.00 Incl. of GSTRaspberry Pi Pico RP2040
- RP2040 microcontroller with 2MByte Flash
- 30 multi-function General Purpose IO (4 can be used for ADC)
- Supply Voltage: 1.8V to 5V
- Micro-USB B port for power and data
- 12-bit 500ksps Analogue to Digital Converter (ADC)
₹320.00 Incl. of GSTRaspberry Pi Pico RP2040
₹320.00 Incl. of GSTEthernet Module ENC28J60 – Big Size
- Ethernet Module ENC28J60 Big Size
- SPI Interface
- 1×10 connector, can be easily mounted with the MCU
- Built-in isolation transformer RJ45 connectors HR911105A
- Power LED
- Single Supply: +3.3 V
- 25Mhz Crystal
₹328.00 Incl. of GSTEthernet Module ENC28J60 – Big Size
₹328.00 Incl. of GSTESP32 Development Board WiFi + BT + BLE
- ESP32-WROOM-32 Based Development board
- It supports WiFi, Bluetooth, Bluetooth Low Energy
- Dual Core MCU
- Clock Frequency of upto 240 Mhz
- Upto 512 KB RAM
- Available Peripherals: Capactive Touch, ADCs, DACs, UART, SPI, I2C and more
₹335.00₹438.96Incl. of GSTESP32 Development Board WiFi + BT + BLE
₹335.00₹438.96Incl. of GST