Mirror Touch Sensor DC 12V 3A – 3 Colour Touch +Dimming
- Functions : Tricolor + Dimming
- Input Voltage: 12V
- Max Load: 12VDC 1A
- LED Indicator: Blue (ON Mode) , White (OFF Mode)
₹136.00₹147.00Incl. of GSTMirror Touch Sensor DC 12V 3A – 3 Colour Touch +Dimming
₹136.00₹147.00Incl. of GST12V 1A DC Supply Adapter – Generic
- Input – 100-240 VAC 50/60Hz
- Category – Switch Mode Power Adapter (SMPS)
- Output Type – DC
- Output – 12Volts 1Amp
- High Quality Adapter with BIS Certificate
₹129.80 Incl. of GST12V 1A DC Supply Adapter – Generic
₹129.80 Incl. of GSTUSB ASP AVR Programmer Module
- Model No.: USB ASP AVR Programming Device for ATMEL Processors
- Compatible with ATMega, Tiny, Classic, CAN, PWM Series
- USB Port for direct connection with PC/Laptop
- 10 pin ISP Header / FRC Output
₹204.00 Incl. of GSTUSB ASP AVR Programmer Module
₹204.00 Incl. of GSTESP32 Programmer Board
- Supports ESP32 and ESP8266
- Can support any MCU that needs BOOT & RESET control
- USB-C Type Interface
- LEDs for Power, RX, TX
- Switch for Reset and Boot
- Both 3.3V and 5V available on the O/P connector
₹519.00 Incl. of GSTESP32 Programmer Board
₹519.00 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
- Operating Voltage: 3.3V – 24V (TTL level for I2C/UART), 3.3V (TTL for SPI)
- Interface: I2C, SPI, High-Speed UART (HSU)
- Communication Distance: 5cm to 7cm (NFC and RFID)
- PCB Antenna: Built-in, providing 4cm to 6cm communication range
- Works as an NFC device or RFID reader/writer
₹268.00 Incl. of GSTPN532 NFC RFID Read Write Module Kit V3
₹268.00 Incl. of GSTSTM32F103C8T6 Module – ST Development Board
- STM32F103C8T6 Original MCU From ST
- Arm 32Bit Core M3 based Core
- 8Mhz OnBoard Crystal
- Working Voltage: 2.0 to 3.6V
- Almost all I/O are 5V tolerant
- Upto 37 I/Os
- USB 2.0 Full Speed
₹185.50 Incl. of GSTSTM32F103C8T6 Module – ST Development Board
₹185.50 Incl. of GST300W Step Down DC-DC Buck Converter with Constant Voltage and Current Control – CC – CV – 20A
- Output Voltage: 1.2V to 36V DC
- Input Voltage: 6V to 40V DC
- Output Current: 20A(max.)
- Efficiency: 95%(24V to 12V, 20A)
- Output Ripple: ≤50mV
- Wiring Method: Terminal
- Short Circuit Protection: Self-recovery(cannot short circuit for long time)
₹428.00 Incl. of GSTAutomatic Hand Sanitizer Dispenser Kit
- Automatic Sanitizer Dispenser Kit
- Operating Voltage: 12V DC
- Current Required: 400 mA Max, 100 mA Continuous
- Sanitizer Output: 2-3 ml on each trigger
- Buzzer Plays on a trigger
- Alternate Product : Solderless Sanitizer Dispenser Kit
₹1,119.82₹1,534.00Incl. of GSTAutomatic Hand Sanitizer Dispenser Kit
₹1,119.82₹1,534.00Incl. of GSTTB6600 Stepper Motor Driver Module
- Output Current: 0.5-4.0A
- Control Signal: 3.3~24V
- Power (MAX): 160W
- Micro Step: 1, 2/A, 2/B, 4, 8, 16, 32
- Temperature: -10~45℃
- Humidity: No Condensation
₹393.00₹571.12Incl. of GSTTB6600 Stepper Motor Driver Module
₹393.00₹571.12Incl. of GSTIP6505 24W USB Fast Charging Module – QC2.0 QC3.0 Apple Samsung BC1.2 Support – Step Down Module
- Input Voltage Surge: Handles up to 48V surge
- Input Voltage Range: 6V to 32V
- Output Voltage Range: 3V to 12V; supports up to 24W output power
- Supported Fast Charging Protocol: FCP,AFC,SFCP,SCP
- Conversion Efficiency: Up to 97.5%
₹67.90 Incl. of GSTSIMCOM A7672S IC with GNSS and BLE
- Supply Voltage: 3.4V to 4.2V.
- Supports LTE-TDD/LTE-FDD/GSM/GPRS/EDGE.
- Supports maximum For LTE is 10Mbps downlink rate and 5Mbps uplink rate.
- EDGE Uplink/Downlink Up to 236.8Kbps.
- GPRS Uplink/Downlink Up to 85.6Kbps.
- Control via AT commands.
₹1,380.00 Incl. of GSTSIMCOM A7672S IC with GNSS and BLE
₹1,380.00 Incl. of GSTPWM DC Motor Controller – 5V to 35V – 5A – LED Dimmer Module
- Operating voltage: DC4.5V-35V
- Output current: 0-5A
- Output power: 70W (max)
- PWM duty cycle: 1% -100%.
- PWM frequency: 20khz
- LED Dimmer Switch Module
- DC Motor PWM Speed Controller Module
₹57.50 Incl. of GSTPWM DC Motor Controller – 5V to 35V – 5A – LED Dimmer Module
₹57.50 Incl. of GST