No products in the cart.
Roll over image to zoom in
TP5100 Dual/Single 8.4V/4.2V Li-ion Battery Charging Module
₹53.50 (Incl. of GST 18%)
GST Credit of ₹8.16available.
Know More
- Dual/Single 4.2V/8.4V Li-ion Battery Charger
- Input Voltage: 5V to 18V
- Programmable Charge Current: 0.1A to 2A
- Chip temperature protection, Overcurrent protection, undervoltage protection
- Reverse Battery Shutdown, and short circuit protection
- Trickle, constant current, constant voltage charging 3 states of charging
Description
TP5100 is a step down double 8.4V/4.2V single lithium battery charge management module. It has in-built overcurrent, under voltage, short circuit protection. Along with this it also provides over temperature, and reverse battery shutdown protection.
The TP5100 Module can charge either single or double lithium ion cell battery. It has wide input voltage range of 5V to 18V. It has Maximum charging current of 2A.
The TP5100 Module has frequency of 400Khz switching mode. So it becomes possible to use smaller capacitors, and peripherals. And also enables maintaining of smaller amount of heat in high current charging. It has charging indicator LED.
The default charging mode is for 4.2V. To enable the 8.4V Charging mode, the SET pin needs to be soldered.
- Dual/Single 8.4V/4.2V Lithium Battery Charger
- Built-in MOSFET, switching mode regulator
- Programmable charge current: 0.1A to 2A
- Wide operating voltage: 5V to 18V
- Blue Light = Full Charge, Red Light = Charging
- Jumper pins (SET) to enable 8.4V charging mode
- Protection : Chip temperature, overcurrent, undervoltage
- 3 charge methods: pre-charge trickle charging, constant current, constant voltage
Specification
Additional information
| Weight | 7 g |
|---|
by anil.motwani (verified owner)
Good quality. The TP5100 also place to put a common anode two tone LED for status of charging 1s or 2s depending on the SET pin.
The module comes with a 220 marked inductor. Permits using 12v for charging.
by anil.motwani (verified owner)
Good quality. The TP5100 also place to put a common anode two tone LED for status of charging 1s or 2s depending on the SET pin. Reasonably priced.
The module comes with a 220 marked inductor. Permits using 12v for charging.
by alok (verified owner)
Very appreciative packing timely delivery and flawless quality. Thanks so much. This was my first purchase with you. Will come back soon